Universal loom for easy installation. This set contain proffesional FLRY wires for the automotive industry. Each wire is connected with a Ecumaster connector pin. There are 43 wires with this set. Wires: 19 wires 0.5mm 12 wires 0.75mm 9 wires 1mm (including 6 wires LGY for ignition) 3 wires 1.5mm
CAN keyboards in completion to our range of product, we can also offer CAN-bus based keyboard (available in few different keys pattern) Built in LEDs are indicating buttons state (red, green, orange) and additionally serving as back-lit for the keyboard. The behavior of the individual keys is fully configurable in the EMU Black or PMU client software.
The EMU is well established on the market stand alone engine management system. It is designed to operate the most advanced and complex engines presently available. The EMU controls fueling, ignition and auxiliary systems on 1-12 cylinder engines including those with drive-by-wire throttles and VVT.
Data logger EDL-1 is a “must have” for any proffesionals using EMU and EMU BLACK device. Utilizing serial communication, device is able to record over 200 data channels with frequency of 25Hz. The average data rate allows to record about 11 hours per 1GB of memory card space. DL-1 device is equipped with Bluetooth module to communicate with Android tablet...
Wireless communication module to connect with mobile phones to ECUMASTER EMU.With this Bluetooth module it's possible to connect you mobile or tablet device to the ECUMASTER EMU. Only compatible with Android. This module is connected true the Can Bus communication port.
The PMU-16 is replacing of the old fashioned relays and fuses. The relays and fuses sent the lights, data loggers and the electrical components. This meant the fuses and relays are warm and very sensitive. Now is the solution to bought the PMU-Ecumaster 16.
A CAN switch board is a tiny device to allow easy transfer of up to 8 switch states and 8 analog signals over the CAN bus. In addition to this, the device has 4 built-in low side outputs that can be activated with a CAN bus message. The main purpose of this board is to build custom steering wheel panels containing buttons, rotary switches and indicators.